HYDAC CS 1000 - Manual (Page 13)

ContaminationSensor CS1000 New features — instruction modifications
HYDAC Filtertechnik GmbH en Page 13 / 100
BeWa CS1000 3247149n en 2009-02-04.doc 2009-02-04
New features — instruction modifications
The index is noted on the cover sheet of the operating and maintenance instructions
and in the lower left corner after the part number on each page.
Index "m" — from firmware version V 2.20
- Display range limited to ISO 9/8/7 – ISO 25/24/23
- Change in the switching behavior of the switching output (open /
conductive)
- Change of status / error messages (<9/<8
Index "n" — from firmware version V 2.20
- HDA.ISO Signal Table, values adjusted
- HDA Status Signal 5, Definition for I=8 mA / U=4 V corrected
- Hazard indications adopted from ANSI 535
- Chapter modification "Connecting CSI-D-5"
Storing ContaminationSensor
Store the CS in a clean, dry place, in the original packing, if possible. Do not remove
the packing until you are ready to install the unit.
If the CS is to be put into storage for an extended period of time, it should be
completely drained and flushed with Cleanoil to prevent it from gumming up.
After a storage period of 6 months, we recommend flushing with Cleanoil.
Properly dispose of the cleaning agents and flushing oils used.
Storage conditions
Storage temperature -40 °C to +80 °C / -40 °F to +176 °F
Relative humidity: max. 95%, non-condensing