HYDAC CS 1000 - Manual (Page 42)

ContaminationSensor CS1000 Overview of menu structure
HYDAC Filtertechnik GmbH en Page 42 / 100
BeWa CS1000 3247149n en 2009-02-04.doc 2009-02-04
Overview of menu structure
Menu CS 12xx (ISO 4406:1999 and SAE)
Power Up Menu
Measuring mode (MODE)
Mode „1“ (M1)
Mode 2 (M2)
Mode „3“ (M3)
Mode „4“ (M4)
Mode „Single“ (SINGLE)
Measuring time (mTIME)
Set value (60)
Pump protection (pPRTCT)
Set value (0)
Bus address (ADRESS)
HECOM3b address (HECOM)
Set value (A)
(IP) reserved for future use
(MODBUS) reserved for future use
Factory defaults (DFAULT)
Cancel (CANCEL)
Save changes, leave Power Up Menu (SAVE)
For internal use (CODE)
Measuring menu
Display (DSPLAY)
ISO-Code (ISO)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
SAE A-D (SAeMAX)
Flow rate (FLOW)
Analog output (ANaOUT)
Measuring cell LED current (DRIVE)
Temperature (TEMP C)
Temperature (TEMP F)
Switching output (SWtOUT)
Mode „1“ (M1)
No settings necessary (NO SET)
Mode 2 (M2)
Switching point (SP1)
Measuring channel (MEAsCH)
SAE A-D (SAeMAX)
SAE class A/B/C/D (SAE)
ISO-class 4µm (ISO 4)
ISO-class 6µm (ISO 6)
ISO-class 14µm (ISO 14)
ISO Code (ISO)
Temperature (TEMP)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
Switching function (SwFNCT)
Beyond limit (BEYOND)
Below limit (BELOW)
Within band (WITHIN)
Outside band (OUTSDE)
No switch (OFF)
Limits (LIMITS)
Lower limit (LOWER)
Mode „3“ (M3) Upper limit (RSTART)
Measuring channel (MEAsCH)
Target cleanliness (TARGET) ISO (ISO)
Mode „4“ (M4) SAE (SAE)
Measuring channel (MEAsCH)
Target cleanliness (TARGET) ISO (ISO)
Upper limit (RSTART) SAE (SAE)
Test cycle time (CYCLE)
Mode „Single“ (SINGLE) Set value (60)