ACU-RITE MILLPWRG2 - Manual (Page 60)

42 3 DRO Mode and Calculator
3.2 Calculat
or
More Commands, second menu.
 To exit the calculator press the CALC key a second time
or press CANCEL.
 Press the CLEAR key to clear the entry field.
Using the calculator to insert data
The calculator can be used in the numeric field of dialogues.
Example, Milling a circle pocket:
The radius of a circle is required in the data input field, and the part
drawing provides a diameter dimension.
 The diameter dimension can be entered into the dialogue field.
 Make sure CALC has been pressed to activate the calculator.
 Then press the Divide by key. The ( ÷ ) divide by
symbol will appear in the field showing the calculation
step.
 Then press the 2 key. This will also appear in the field
as part of the calculation steps.
 Then press the ENTER key, and the result will be
entered into the dialogue field.
Trig Functions
When calculating the Sine, Cosine, or Tangent of an angle, enter the
angle first (in decimal degrees), then press the function soft key.
Soft key Description
ArcSin
Inverse function of Sine
ArcCos
Inverse function of Cosine
ArcTan
Inverse function of Tangent