ACU-RITE MILLPWRG2 - Manual (Page 117)

ACU-RITE MILLPWR G2 99
6.2 F
o
lders
G-code and M-Code Definitions
G-code
The following is a list of supported, and unsupported G-codes.
† Represents supported G-codes.
G-code Listing
G-code Description Comment
G0 † Linear Interpolation (Rapid)
These commands generate table/quill motion. The motion command
applies to current and subsequent blocks containing at least one X, Y, or
Z coordinate. The default motion command is a linear move at feed (G1). G1 † Linear Interpolation (Feed)
G2 † Circular Interpolation (CW)
G3 † Circular Interpolation (CCW)
G4 † Dwell
This command causes the system to pause for the specified period of
time. The period of time is determined by the P address (in milliseconds)
or X address (in seconds). T Address also specifies the time in seconds.
G17 † XY Plane Selection
These commands set the plane in which arcs are executed. The setting
applies to current and subsequent blocks. The default is G17 (XY).
G18 † XZ Plane Selection
G19 † YZ Plane Selection
G20 † Set Program Units (INCH) Same functions as G70 and G71. These commands set the unit of
measure. The setting applies to current and subsequent blocks. The
default is G20 (INCH).
G21 † Set Program Units (MM)