ACU-RITE MILLPWRG2 - Manual (Page 141)

ACU-RITE MILLPWR G2 123
7.
1 Demonstr
ation Pr
ogr
am
Programming the Rectangular Pocket
 Press the RECT key.
A popup menu will appear for selecting the type of rectangle to be
milled.
 Highlight Pocket and press the ENTER key. The RECTANGLE
POCKET dialogue will be displayed. The cursor will default to the
first field (X1).
 In the 1st CORNER: X1 field enter -2.0.
 In the 1st CORNER: Y1 field enter -1.0.
 ARROW down to SIZE: X field and enter 0.5
 ARROW down to SIZE: Y field and enter 2.0.
The 2nd CORNER fields will automatically fill in based on the data from
the 1st CORNER: fields, and the SIZE: fields.
The Z: begin field, and Z: End field inserts the same information that
was entered for the BOLT CIRCLE dialogue information.
 ARROW down to highlight the Z: BEGIN field and enter .100.
 ARROW down to highlight the Z: END field and enter -.25.
 ARROW down to highlight the Z: PASS field, and enter 4 for the
NUMBER.
 ARROW down to the CORNER BLEND RADIUS: field, and enter 0.125.
 ARROW down to highlight the DIRECTION field, and select CW
(Clock Wise) by pressing the CW soft key.
 Press the USE key.
The demonstration program is now complete.
 Save the program, replacing the existing program.