ACU-RITE MILLPWRG2 - Manual (Page 21)

ACU-RITE MILLPWR G2 3
1
.1 MILLPWR
G2
Powering Up
 Turn the power switch On [1], (to the I position) on the MILLPWR
G2
console which is located on the back of the unit.
 Follow the builder’s instructions to turn off the machine.
 The start up screen with 3 soft keys will be displayed; Shut Down,
Find Home
, and Cancel. After pressing either the Find Home, or
Cancel soft key, the default DRO screen will be displayed.
 If a program was loaded when the MILLPWR G2 was shut down, that
same program will be reloaded when the unit is powered up again.
The MILLPWR
G2
console does not disconnect the power
supply to the spindle motor. It can only be disconnected
by turning off the main power supply.
It is strongly recommended that the MILLPWR
G2
performs the Find Home feature at start up, prior to any
other action taken.
If the MILLPWR
G2
did not perform the Find Home feature
at start up, press the Datum soft key from the default DRO
screen to display the Home soft key. Press the Home soft
key then the Find Home soft key will be displayed.