Toshiba Gigashot A Series - Manual (Page 35)

Owner’s Manual 13
Hard Disk Camera GSC-A100FE/GSC-A40FE
Turning the Camera On and Off by Sliding the POWER Switch
Setting the Date and Time
The first time you use the camera, when the battery has been left out of the
camera for some time or when the date and time have not been set, the
screen for setting the date and time automatically appears.
1. Select the [DATE].
Move the OK ( ) button up or down to select [DATE] and then press
the OK ( ) button.
Sliding the POWER switch turns the
camera on and off.
MEMO
If the camera is not used for a set period of time, it automatically turns
off to avoid wasting battery power. This is referred to as Auto power off
(
p.113).
To forcibly turn off the camera when there is a problem such as a
system error, slide the POWER switch across and hold it in place for at
least 5 seconds. Note that this may result in the loss of any files that are
being created. Settings such as the date and time may also revert to
their default values. In this event, reset the settings before using the
camera again.
You can start the camera up more quickly by setting [QUICK START]
(
p.115) to [ON].
IMPORTANT
If you slide the battery lock lever when the AC adapter is not connected,
the camera will automatically turn off.
DD/MM/YYYY
DATE AND TIME SETTING
DATE
TIME
FORMAT
OK
SELECT CHANGE