Toshiba Gigashot A Series - Manual (Page 137)

Owner’s Manual 115
Hard Disk Camera GSC-A100FE/GSC-A40FE
Using Quick Start
Quick start enables you to quickly re-activate the camera when it is in
standby mode (
p.116).
What is Standby Mode?
Standby mode is an intermediate state between being turned on and being
turned off. The systems needed to start up are still active, but all other
systems are shut down.
Setting [QUICK START] to [ON] allows you to switch between standby
mode and quick start operation.
1. From the setup menu ( p.36), select [QUICK START] .
Use the jog dial to select [QUICK START] and then press the OK ( )
button.
2. Select [ON].
Use the jog dial to select [ON] and then press the OK ( ) button.
ATTENTION
In standby mode, the camera uses more battery charge than when it is
turned off.
In standby mode, the lens barrier stays open for faster startup. Take
care not to touch or damage the lens.
ON: Standby is used for faster camera startup.
OFF: Standby is not used.
SETUP
AUTO POWER OFF
IMAGE OUTPUT TERMINAL
EXIT
OFF
HDMI OUTPUT
QUICK START
LCD-LINKED POWER
ON
SETUP
QUICK START
RETURN