Toshiba Gigashot A Series - Manual (Page 103)

Owner’s Manual 81
Hard Disk Camera GSC-A100FE/GSC-A40FE
Changing the Metering Mode
Use this procedure to set the metering mode used to calculate the image
brightness.
1. From the recording menu ( p.34), select [METERING MODE].
Use the jog dial to select [METERING MODE] and then press the OK
( ) button.
2. Select the desired setting.
Use the jog dial to select the desired setting and then press the OK ( )
button.
POINT
Using the [SPOT] setting for backlit subjects enables you to match the
exposure for a specific subject.
ATTENTION
If the metering point is too bright, the photographed image will be dark.
If the metering point is too dark, the photographed image will be
washed out.
EVALUATIVE METERING: Sets the exposure by dividing the image
into sections and metering of each section.
SPOT: Sets the exposure by metering a small area
in the center of the image.
RECORDING MENU
MIC. SENSITIVITY
EVALUATIVE METERING
AF ASSIST LIGHT
EXIT
AUTO GUIDE LAMP
METERING MODE
DIGITAL ZOOM
EVALUATIVE METERING
RECORDING MENU
CANCEL
METERING MODE
MEMO
Setting the camera to Auto mode selects [EVALUATIVE METERING]
as the metering mode.