Toshiba Gigashot A Series - Manual (Page 138)

116 Owner’s Manual
Hard Disk Camera GSC-A100FE/GSC-A40FE
Putting the Camera on Standby
Preparation
Set [QUICK START] to [ON].
1. Turn the camera off.
Close the LCD monitor or slide the POWER switch to turn the camera
off (
p.13).
Because [QUICK START] is set to [ON], the camera switches to
standby mode rather than shutting down.
Starting Up with Quick Start
Preparation
Standby mode
1. Start up the camera.
You can start up the camera in any of the ways shown below.
MEMO
After approximately 20 minutes in standby mode, the camera
automatically turns off. Once this happens, quick start is no longer
enabled.
To turn the camera off completely rather than switching to standby
mode, or to turn the camera off when it is already in standby mode,
slide and hold the POWER switch for approximately 2 seconds.
• Open the LCD monitor. • Slide the POWER switch.
• Press the REC button. • Press the REC button.
(Video recording begins after the
camera starts up.)