Toshiba Gigashot A Series - Manual (Page 29)

Owner’s Manual 7
Hard Disk Camera GSC-A100FE/GSC-A40FE
Camera Operation Time Using the Battery
The length of time for which the camera will operate on battery power
varies considerably depending on a number of factors, including the
battery’s storage time, the temperature of the battery and camera, and the
shooting conditions (whether the flash and zoom are used, etc.). Dirt and/or
other debris on the positive (+) and/or negative (-) battery terminals, or on
the corresponding terminals in the camera, can obstruct current flow and
the camera to incorrectly indicate that the battery is not charged. When
loading and removing the battery, take care not to touch the battery or
camera terminals. If the battery and/or camera terminals are dirty, clean
them with a clean, dry cloth.
The available video recording times when a new battery (GSC-BT6) is fully
charged are shown below.
Continuous video recording
Actual time video recording
* The figures above relating to video recording time are for reference
purposes only and are not guaranteed.
Removing the Battery
1. Remove the battery.
Conditions: Recording a video continuously without using the
zoom at a temperature of 73°F (23°C)
Shooting time: Approx. 75 min.
Conditions: Recording a video using the zoom and power ON/
OFF at a temperature of 73°F (23°C)
Shooting time: Approx. 45 min.
IMPORTANT
Always turn the camera off before removing the battery. Removing the
battery while the camera is still turned on may damage the camera or
corrupt important data. It may also cause the camera settings to revert
to the defaults that were set when you purchased the camera. If this
occurs, specify your preferred settings again.
If you slide the battery lock lever when the AC adapter is not connected,
the camera will automatically turn off.
Slide the battery lock lever in the direction of
the arrow .
Take the battery out in the direction indicated
by the arrow .