AMD Geode SC1201 - Manual (Page 59)

AMD Geode™ SC1200/SC1201 Processor Data Book 59
Signal Definitions 32579B
3.4.8 Sub-ISA Interface Signals
Signal Name Ball No. Type Description Mux
A[23:0] See
Table 3-3
on page
40
O Address Lines AD[23:0]
D15 See
Table 3-3
on page
40
I/O Data Bus STOP#
D14 IRDY#
D13 TRDY#
D12 PAR
D11 C/BE3#
D10 C/BE2#
D9 C/BE1#
D8 C/BE0#
D[7:0] AD[31:24]
BHE# E4 O Byte High Enable. With A0, defines byte accessed for
16 bit wide bus cycles. DEVSEL#
IOCS1# D10 O I/O Chip Selects GPIO1+TFTD12
N30 AB1D+GPIO1
IOCS0# A10 GPIO17+TFTDCK
ROMCS# C8 O ROM or Flash ROM Chip Select BOOT16 (Strap)
DOCCS# A9 O DiskOnChip or NAND Flash Chip Select GPIO20+TFTD0
N31 AB1C+GPIO20
TRDE# D11 O Transceiver Data Enable Control. Active low for Sub-
ISA data transfers. The signal timing is as follows:
• In a read cycle, TRDE# has the same timing as RD#.
• In a write cycle, TRDE# is asserted (to active low) at
the time WR# is asserted. It continues being asserted
for one PCI clock cycle after WR# has been negated,
then it is negated.
GPIO0
RD# B8 O Memory or I/O Read. Active on any read cycle. CLKSEL0 (Strap)
WR# B9 O Memory or I/O Write. Active on any write cycle. ---
IOR# D9 O I/O Read. Active on any I/O read cycle. DOCR#+GPIO14
IOW# A8 O I/O Write. Active on any I/O write cycle. DOCW#+GPIO15
DOCR# D9 O DiskOnChip or NAND Flash Read. Active on any mem-
ory read cycle to DiskOnChip. IOR#+GPIO14
DOCW# A8 O DiskOnChip or NAND Flash Write. Active on any mem-
ory write cycle to DiskOnChip. IOW#+GPIO15
IRQ9 AA3 I Interrupt 9 Request Input. Active high.
Note: If IRQ9 function is selected but not used, tie
IRQ9 low.
IDE_DATA6
IOCHRDY C9 I I/O Channel Ready
Note: If IOCHRDY function is selected but not used, tie
IOCHRDY high.
GPIO19+INTC#