beautypg.com

AMD Geode SC1201 User Manual

Page 294

background image

294

AMD Geode™ SC1200/SC1201 Processor Data Book

Core Logic Module - USB Controller Registers - PCIUSB

32579B

8

Read: PortPowerStatus. This bit reflects the power state of the port regardless of the power switching mode.

0: Port power is off.

1: Port power is on.

If NoPowerSwitching is set, this bit is always read as 1.

Write: SetPortPower. Writing a 1 sets PortPowerStatus. Writing a 0 has no effect.

7:5

Reserved. Read/Write 0s.

4

Read: PortResetStatus.

0: Port reset signal is not active.

1: Port reset signal is active.

Write: SetPortReset. Writing a 1 sets PortResetStatus. Writing a 0 has no effect.

3

Read: PortOverCurrentIndicator. This bit reflects the state of the OVRCUR pin dedicated to this port. This field is only
valid if NoOverCurrentProtection is cleared and OverCurrentProtectionMode is set.

0: No over-current condition.

1: Over-current condition.

Write: ClearPortSuspend. Writing a 1 initiates the selective resume sequence for the port. Writing a 0 has no effect.

2

Read: PortSuspendStatus.

0: Port is not suspended.

1: Port is selectively suspended.

Write: SetPortSuspend. Writing a 1 sets PortSuspendStatus. Writing a 0 has no effect.

1

Read: PortEnableStatus.

0: Port disabled.

1: Port enabled.

Write: SetPortEnable. Writing a 1 sets PortEnableStatus. Writing a 0 has no effect.

0

Read: CurrentConnectStatus.

0: No device connected.

1: Device connected.

If DeviceRemoveable is set (not removable) this bit is always 1.

Write: ClearPortEnable. Writing 1 a clears PortEnableStatus. Writing a 0 has no effect.

Note:

This register is reset by the UsbReset state.

Offset 60h-9Fh

Reserved

Reset Value = xxh

Table 6-42. USB_BAR+Memory Offset: USB Controller Registers (Continued)

Bit

Description

This manual is related to the following products: