Xerox WorkCentre C2424-3833 - Manual (Page 192)

UNIX (Linux)
WorkCentre® C2424 Copier-Printer
6-42
UNIX (Linux)
This section includes:
■ "Quick Install Steps" on page 6-42
■ "Additional Resources" on page 6-43
Your system supports connection to a variety of UNIX platforms through the network
interface. The workstations currently supported by CentreWare for UNIX/Linux to a network-
connected system are:
■ Sun Solaris
■ IBM AIX
■ Hewlett-Packard HP-UX
■ DEC UNIX
■ Linux (i386)
■ Linux (PPC)
■ SGI IRIX
The following procedures enable you to connect your system using any of the supported
versions of UNIX or Linux listed above.
Quick Install Steps
From the System
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. At the control panel, select one of these IP address options:
■ Allow the copier-printer system to set up a DHCP address.
■ Enter the IP address manually.
3. Print the “Configuration Page” and keep it for reference.
From Your Computer
1. Access www.xerox.com/office/drivers .
2. Select your system, the platform you are running (UNIX), and file type (Drivers).
3. Click Go to Downloads.
4. From the list of files provided, download the PrinterPackageXPXX and the file that
matches your operating system.
5. Print a test page.
6. Verify the print quality of the printed page.
Note
If print-quality problems exist, or if your job did not print, see the Troubleshooting section
of this guide. You can also access PhaserSMART Technical Support through
CentreWare IS.