Xerox WorkCentre C2424-3833 - Manual (Page 177)

Windows 98 and Windows Me
WorkCentre® C2424 Copier-Printer
6-27
Configuring a Port
The Xerox TCP/IP Printer Port Wizard guides you step-by-step through the following
procedures:
■ Choosing a name for the new port
■ Identifying a system by its DNS Name or IP Address
■ (Alternatively) Identifying a system using the automatic Printer Discovery feature
1. Click Next to proceed with the port installation. The wizard verifies the port name and
system address, then automatically configures the remaining port settings. Any errors
detected are displayed in a dialog box requesting Additional Information.
2. In the Add Xerox TCP/IP Port window:
■ Enter a unique name for the port being added in the Enter a Port Name section.
■ Enter the system host name or IP Address in the Enter a Printer Name or IP
Address section.
3. Click Next.
Note
To locate Xerox systems on your local area network, select Auto Printer Discovery, then
click Refresh. The Xerox TCP/IP Port Monitor searches the network for Xerox systems
and displays them in a list. Select your desired system from the list, then click OK.
Completing the System Port TCP/IP
After the port settings have been configured and verified, a Completing dialog box appears
summarizing all the settings. You can change or select system port settings.
1. Select one of these options:
■ Click Finish to complete the system port setup.
■ Click Back to change the settings. When you have completed the changes, click
Finish to complete the system setup.
2. Click OK to exit Printer Properties.
PhaserPort Software
Note
PhaserPort is the preferred utility for PostScript installations. For PCL installations, go to
“Xerox TCP/IP Port Monitor” in this section.
The Windows installer installs PhaserPort for Windows (for those installations using
PostScript drivers). PhaserPort for Windows is a Xerox print monitor for printing over
Windows 98 or Windows Me TCP/IP peer-to-peer networks.