Xerox WorkCentre C2424-3833 User Manual
Page 130
Specialty Paper
WorkCentre® C2424 Copier-Printer
5-45
5.
On the control panel:
a.
Select
Change
, then press the Enter button.
b.
Select the paper size, then press the Enter button.
c.
Select
Special
for paper type, then press the Enter button to save your selection.
6.
In the printer driver, select Tray 1 as the paper source.
Note
Do not select Proof Prints during the print job. It will disturb the sequence of the
pre-collated sets.
7.
To ensure the carbonless paper sets are properly loaded in the tray:
a.
Print one complete set.
b.
Remove the set from the output tray.
c.
Mark the top, white sheet of the printed set with a pen or a pencil.
■
If the paper is loaded correctly, the mark should appear on the printed side of the
subsequent colored sheets within a few seconds.
■
If a mark does not appear, repeat Steps 1–7 to make sure the paper is loaded correctly.
Printing Xerox Carbonless Paper from Tray 2, 3, or 4
1.
Pull the tray completely out of the system.
2424-001