Xerox WorkCentre C2424-3833 - Manual (Page 182)

Macintosh
WorkCentre® C2424 Copier-Printer
6-32
Enabling and Using TCP/IP for Mac OS 9.x
This section provides installation and troubleshooting steps for Macintosh OS 9.x.
Setting Up the Macintosh Ethernet Port for TCP/IP
Perform the following procedure to set up your Macintosh for TCP/IP:
1. Select Network from the System Preferences application, then select TCP/IP.
2. Select Built-In Ethernet from the Active Ports menu.
3. Specify how you will obtain the IP address from the TCP/IP tab:
■ Manually: Specify the IP address, Subnet Mask, Router Address, and Name Server
Address in the dialog box.
■ DHCP: Automatically finds the IP address.
■ AppleTalk: Select the AppleTalk tab, then verify that the Make AppleTalk Active
box is selected.
4. Close the dialog box.
For more information, go to the table of infoSMART Knowledge Base documents at the end of
this section.
Creating an LPR System with LaserWriter 8.5.1 or Higher
1. Open the Desktop Printer Utility. This utility, or an alias to it, can be found in the
PhaserTools folder.
2. Click Printer (LPR) in Create Desktop, then click OK.
3. Click Change in the PostScript Printer Description (PPD) file.
4. Select the appropriate PPD from the list, then click Select. If your system PPD is not
listed, install it from the WorkCentre C2424 Software CD-ROM.
5. Click Change in LPR Printer Selection.
6. Enter information in the following fields:
■ Printer Address: Enter the system’s IP address or domain name.
■ Queue: Enter PS (use upper-case), then click OK.
7. Close the dialog box. When prompted, click Save.
8. Enter a name for the desktop system in Save Desktop Printer As field, then click Save.
9. Two methods are available for printing through LPR:
■ Use the new Desktop Printer (LPR).
■ Use the LaserWriter 8.5.1 device driver (any device can be selected). Click File, then
click Print to select the appropriate LPR device in the Printer drop-down list.