Xerox WorkCentre C2424-3833 - Manual (Page 133)

Specialty Paper
WorkCentre® C2424 Copier-Printer
5-48
8. In the printer driver, select the appropriate tray as the paper source.
Note
Do not select Proof Prints during the print job. It will disturb the sequence of the pre-
collated sets.
9. To ensure the carbonless paper sets are properly loaded in the tray:
a. Print one complete set.
b. Remove the printed set from the output tray.
c. Mark the top, white sheet of the printed set with a pen or a pencil.
■ If the paper is loaded correctly, the mark should appear on the printed side of the
subsequent colored sheets within a few seconds.
■ If a mark does not appear, repeat Steps 1–9 to make sure the paper is loaded correctly.