Konica Minolta bizhub PRESS C7000 - Manual (Page 31)

9. After each color sweep, wait for the check mark to appear next
to the appropriate icon, and follow the on-screen instructions.
Note: Make sure that you scan each separation on the chart in the order
in which the icons appear: cyan, magenta, yellow, and then black.
When all of the separation columns have been successfully
scanned, a check mark appears next to all the icons.
Notes:
● If at any stage the scanning is not completed properly, click Reset
and scan again.
● If an error occurs while you are scanning the chart, an alert message
appears. Click OK and rescan the chart.
10. Click Next.
11. To save the calibration table, perform one of the actions:
● Select As default name to automatically name the
calibration table using the screening method, media type,
and date.
● Select Save as to type your own name.
Note: It is strongly recommended that you include the media type,
weight, and screening method in the calibration table file name.
12. Select the media type to which to apply the calibration table.
13. Click Finish.
Troubleshooting calibration
Resolve common troubleshooting problems that can occur during
the calibration process.
Message Recovery action
Values
collected
during the
measurement
are not
monotonous. This message may appear after calibration
measurements are successfully measured. Clicking OK
enables the calibration process to continue without any
problem.
The Eye-One
is not
calibrated.
Place it on
the base
and click
OK to
proceed. Place the X-rite i1 back on its base in order to re-
calibrate it.
Troubleshooting calibration 21