Konica Minolta bizhub PRESS C7000 - Manual (Page 111)

on every page and are automatically created based on the
following settings in your job:
○ Number of sets
○ Sheet ID
○ Number of sheets in one set
Generating a corner mark, barcode, and end mark
Generate a barcode, registration mark, end mark, or corner mark,
and print the finishing marks for a near-line finisher
Requirements:
Make sure that you program the job details on the near-line
finisher that you are going to use.
1. Open the job parameters window for the desired job.
2. In the Finishing tab, select Near-line finisher.
3. In the Device list, select the finisher that you want to use—for
example, Duplo DSF-2000.
Note: Depending on the finisher you select, some of the options may
vary.
4. To print a corner mark, select the Generate corner mark
check box.
5. To print a barcode, select the Generate barcode check box.
6. In the Position list, select the area on the page on which to
place the corner mark and barcode.
7. In the Side list, select on which side to place the corner mark
and barcode.
8. To adjust the offset of the corner mark, in the Corner mark
offset boxes, enter the horizontal distance and vertical
distance.
9. To adjust the offset of the barcode, in the Barcode offset
boxes, enter the horizontal distance and vertical distance.
10. To print an end mark, select the End mark check box.
11. In the Side list, select on which side of the sheet to place the
end mark.
12. In the Position list, select the area on the page on which to
place the end mark.
13. To offset the end mark from the center, in the Offset from
center box, enter the distance.
14. In the Mark width box, enter the thickness of the end mark.
15. Click Save, and then submit your job for printing.
Generating a corner mark, barcode, and end mark 101