Konica Minolta bizhub PRESS C7000 - Manual (Page 131)

Parameter Option Description
Size Paper size The size of the actual piece of paper on which your job
pages are imposed and then printed.
Note: For custom paper sizes, you need to specify the
required width and height.
Trim size The size of the finished, trimmed document. For custom trim
sizes, you must specify a width and height.
Tip: You can adjust your page size by adjusting the trim
size. If you set the trim size smaller than the page size set in
the DTP application, the data will be cropped. Setting a
larger trim size results in a larger border on the printed page.
Trim orientation Displays the orientation, portrait or landscape, for the trim
size you selected.
If the wrong orientation is selected, the job might be cropped
as a result.
Templates Layout Provides the following options:
● Best Fit—Automatically calculates the most suitable
number of columns and rows.
Note: This option is not available for the saddle-stitch
and perfect bound imposition methods.
● Custom—Enables you to specify how many pages to
place horizontally (Rows) and vertically (Columns) in a
custom layout.
Note: Templates that are created or imported via the
Imposition Template Builder are also available.
Print method Provides the following options for how the document will be
printed:
● Simplex
Note: This option is not available for the saddle-stitch
and perfect bound imposition methods.
● Duplex HTH
● Duplex HTT
Binding
selection
Note: This option is available only if the imposition method
is either Saddle stitch or Perfect bound and the template
is 2 x 1, 2 x 2, 4 x 2, or 4 x 4.
North south Places pages 180° from each other, on the same side of the
imposed sheet. Use this option when a step-and-repeat 2 x
1 or 1 x 2 template is selected.
Rotate 90 deg Rotates the entire template 90 degrees to the right, enabling
you to correct imposition conflicts.
Imposition tab in the job parameters window 121