Konica Minolta bizhub PRESS C7000 - Manual (Page 147)

Tray Option
Perfect binder main tray The perfect binder provides the following options:
● Pull Cover from—Enables you to select the
tray that contains the paper on which the cover
will be printed
● Cover content
○ Blank/Preprinted—Cover is not printed as
part of the job
○ Compose from file (Simplex)— Front and
back covers are part of the file and should
be composed and printed on the outside of
the cover sheet
○ Compose from file (Duplex)— Front and
back covers are part of the file and should
be composed and printed on the outside
and inside of the cover sheet
○ Print (Simplex)—Front and back covers are
included on the same page in the file and
are printed on the outside of the cover sheet
○ Print (Duplex)—Front and back covers are
included on the same page in the file and
are printed on the inside and the outside of
the cover sheet
● Cover orientation—Enables you to select the
print orientation of the cover when cover
content is Print (Simplex) or Print (Duplex)
● Spine
○ Blank—Prints a blank spine
○ From file—Prints the spine content
contained on the first page of the file
● Binding
○ Left
○ Right
○ Top
○ Bottom
Notes: Make sure you folow these actions
when you load pre-printed covers into feed
trays:
○ Left Binding—Trays 1, 2, or 3--Load cover
face down, top of cover must point to rear of
machine
○ Left Binding—Bypass, Cover tray, PI1,
PI2--Load cover face up, top of cover must
point to rear of machine
Finishing tab in the job parameters window 137