Konica Minolta bizhub PRESS C7000 - Manual (Page 197)

Parameter Option Description
Operation type Enables you to define the finishing options. The following
IPDS Finishing Options are supported:
● Corner staple
● Saddle stitch out
● Edge stitch
● Fold in
● Separation cut
● Perforation cut
● Z-fold
● Center fold in
● Punch
● Saddle stitch in
Position Enables you to define the finishing position. The following
options are supported:
● Default, unused. This is for use when none of these
positions are applicable to the operation type being
configured, or when you want the operation to use the
printer defaults.
● Bottom, bottom right
● Top, top right
● Top, top left
● Left, bottom left
Activation Enables you to activate any given finishing option using
PJL or current language binary strings.
Deactivation Enables you to deactivate any given finishing option using
PJL or current language binary strings.
Language Enables you to select the binary language. The following
options are supported:
● Current
● PJL/Sys Cmd
Optional Finishing
Execute Command Enables to send an optional finishing command.
Miscellaneous parameters
The Miscellaneous page enables you to change the parameters
for the job begin/end strings, resolutions supported, alternate
duplex selection strings, enabling of special features for a given
back-end language, maximum font caching size where applicable,
and how color simulation, where applicable, is performed.
Parameter Option Description
PJL Supported Enables you to select PJL support (if you are using a
PostScript-based driver).
Miscellaneous parameters 187