Campbell Scientific CR9000X Measurement and Control System - Manual (Page 417)

Appendix D. Status Table
The CR9000X status table contains current system operating status information that can be accessed from
the running CR9000X program or monitored by PC software. Status Table information is easily viewed
by going to LoggerNetTM / PC400 / RTDAQ / PC200W: (| Datalogger | Station Status). However, be
aware that information presented in this Station Status window is not automatically updated. Click the
refresh button each time an update is desired. Alternatively, use the Numeric displays of the connect
screen to show critical values and have these update automatically, or use Devconfig, which polls the
status table at regular intervals without use of a refresh button.
Table D-1 lists the parameters in the Status table with a brief explanation of each.
Table D-1, Status Table Parameters
Field Name Variable
Type
Description
RecNum Long Record number for this set of data from the Status Table.
TimeStamp String Time this record was generated.
OSVersion String Operating system installed in logger.
OSDate String Date that the Operating System was created.
OSSignature Integer Operating System Signature
SlotSrNbr(#) Integer Shows the serial number of the module in the designated slot #.
SlotRev(#) Float Shows the serial number of the module in the designated slot #.
StationName String The Station Name of the data logger. This value is stored in the logger's
memory.
ProgName String Name of the program that is currently running in the data logger.
StartTime Time Time that the running program started running.
RunSignature Float Signature of the compiled binary data structure for the current program. Value
is independent of comments added or non-functional changes to the program.
Often changes with operating system changes.
DLDSignature Float Signature of the current running program file including comments. Does not
change with operating system changes.
SlotModelNbr String Type of Module located in slot #.
Battery(1) Float Voltage of the 3.3 volt lithium battery. Replace the lithium battery if <2.7V.
Battery(2) Float Voltage of the main 12 volt lead acid battery.
CompileResults String Contains error messages generated by compilation or during run time. Returns
"Compiled OK" if there was not any problems with the compilation of the
program.
StartUpCode Integer Displays the program Start-Up Code with results shown below:
Returned Code
Value
Interpretation
0 Current program running from power-up condition.
1 A watchdog reset the data logger.
2 - 7 A software time-out watchdog error occurred.
8 An attempt to write to flash memory failed.
9-19 An instruction hang-up watchdog error occurred.
20 A PC Card watchdog error occurred.
D-1