Campbell Scientific CR9000X Measurement and Control System - Manual (Page 10)

Quick Start
QS1. Setting Up
QS1.1 Installing RTDAQ
A CD with one licensed copy of RTDAQ is provided with every CR9000X.
Locate and install RTDAQ onto a computer with Windows 2000, XP, or
Vista. It is best to install RTDAQ in a sub folder called RTDAQ under a
CampbellSci directory in your root directory.
QS1.2 Opening Enclosure
The CR9000XC and the
CR9000X with Environmental
Enclosure have air-tight seals. It
may be required to press the gas
relief valve on the side of the
enclosure to equalize the internal
and atmospheric pressures in
order to open the enclosure.
QS1.3 Connecting the RS232 Port/ Card Installation
CR9032 CPU
RS-232 CS I/O ETHERNET CARD PC-CARD
MADE IN USA
STATUS
Top of Card Faces Down
CONTROL
SDM
+12 G C1 C2 C3
A nine pin serial cable is supplied with your CR9000X. Plug one end into
your laptop COM port and the other to the CR9032 module's RS232 nine pin
communication port.
If you have either a Type II
Flash card or a compact flash
card, format it (CR9000X
accepts FAT16 or FAT32
formats) and install it into the
PC card slot, face down. When using a Card, the process to remove it is to press
the "Card Removal" button and wait for the Card
Status Led to turn green.
CARD STATUS LED:
Not Lit:
No card detected.
Red: Accessing the card
Yellow: Corrupt Card, Error
Card Status LED
Card Removal
Button
Green: Can safely remove card
QS-2