Campbell Scientific CR9000X Measurement and Control System - Manual (Page 23)

Quick Start
QS2.4 Program Generator Output Table Window
Click on Enable to set-up a Data Table. Click
in the Table Name box and enter a name for
your Data Table (up to 8 characters).
Each table interval is
independently set or
Synchronized to the
program scan interval.
Select mSecs and
enter 50 in the
numeric box (output
to the Table at a rate
of 20 Hz).
Select the
media where
the DataTable
is to be stored
Check the Auto Size box. This will cause the CR9000X to allocate
the largest possible table size for the media selected at compile time.
Specified table sizes will be allocated first, then memory for the
auto-size tables will be allocated to fill at nearly the same time.
Output tables are the data bases created by the CR9000X. They may either
reside within the CR9000X memory or on PCMCIA cards, and may be
accessed with the real-time capabilities of the RTDAQ software. The
Program Generator allows you to create and configure up to 6 tables. Click
on Done after the Data Table is set up.
QS-15