Campbell Scientific CR1000 Measurement and Control System - Manual (Page 547)

Appendix B. Status Table and Settings
547
Table 122. CR1000 Settings
Settings are accessed through the Campbell Scientific Device Configuration Utility (DevConfig) via direct-serial and IP connections, or through
PakBusGraph via most CR1000 supported telecommunications options.
Setting Description Default Entry
Telnet Enabled Set to 1 if the Telnet service should be enabled. This service is disabled by default. 1
Transport Layer Security (TLS)
Enabled
Specifies the password that is used to decrypt the private key file. 0
Reserved Reserved. 0
TLS Certificate File Name Specifies the file name for the x509 certificate in PEM format.
TLS Private Key File Name Specifies the file name for the private key in RSA format.
TLS Private Key Password Specifies the password that is used to decrypt the private key file.
IP Trace COM Port
This setting specifies whether, and on what port TCP/IP trace information is sent. The
type of information that is sent is controlled by the IP Trace Code setting.
Inactive
IP Trace Code
This setting controls what type of information is sent on the port specified by IP Trace
Port and via Telnet. Useful values are:
0
Trace is inactive
1 Startup and watchdog only
2 Verbose PPP
4 Print general informational messages
16 Display net-interface error messages
256 Transport protocol (UDP/TCP/RVD) trace
8192 FTP trace
65535 Trace everything
0
TCP/IP Info Currently DHCP assigned addresses, Domain Name Servers, etc.
MAC:
00d02c042ccb
eth IP:
192.168.1.99
eth mask:
255.255.240.0
eth gw:
192.168.2.19
dns svr1:
192.168.2.25
dns svr2:
192.168.2.16