Campbell Scientific CR1000 Measurement and Control System - Manual (Page 454)

Section 11. Glossary
454
ESS
Environmental Sensor Station
excitation
Application of a precise voltage, usually to a resistive bridge circuit.
execution time
Time required to execute an instruction or group of instructions. If the
execution time of a program exceeds the Scan()
Interval , the program is
executed less frequently than programmed.
expression
A series of words, operators, or numbers that produce a value or result.
Glossary. File Control
File Control is a feature of LoggerNet, PC400 and RTDAQ
(p. 77)
datalogger support software. It provides a view of the CR1000 file
system and a menu of file management commands:
Delete facilitates deletion of a specified file
Send facilitates transfer of a file (typically a CRBasic program file) from
PC memory to CR1000 memory.
Retrieve facilitates collection of files viewed in File Control. If
collecting a data file from a CF card with Retrieve, first stop the
CR1000 program or data corruption may result.
Format formats the selected CR1000 memory device. All files,
including data, on the device will be erased.
LNCMD software
A feature of LoggerNet Setup Screen. In the Setup Screen network map
(Entire Network), click on a CR1000 datalogger node. The File Retieval
tab should be one of several tabs presented at the right of the screen.
Fill and Stop Memory
A memory configuration for data tables forcing a data table to stop
accepting data when full.
final storage
The portion of CR1000 SRAM Memory allocated for storing data tables
with output arrays. Final Storage is a ring memory, with new data
overwriting the oldest data.