Campbell Scientific CR1000 Measurement and Control System - Manual (Page 523)

Appendix A. CRBasic Programming Instructions
523
LoadFieldCal
Loads values from the FieldCal file into variables in the datalogger.
Syntax
LoadFieldCal(CheckSig)
NewFieldCal
Triggers storage of FieldCal values when a new FieldCal file has been written.
Syntax
DataTable (TableName, NewFieldCal, Size)
SampleFieldCal
EndTable
SampleFieldCal
Stores the values in the FieldCal file to a data table.
Syntax
DataTable (TableName, NewFieldCal, Size)
SampleFieldCal
EndTable
A.20 Satellite Systems
Instructions for GOES, ARGOS, INMARSAT-C, OMNISAT. Refer to satellite
transmitter manuals available at www.campbellsci.com.
A.20.1 Argos
ArgosData
Specifies the data to be transmitted to the Argos satellite.
Syntax
ArgosData(ResultCode, ST20Buffer, DataTable, NumRecords,
DataFormat)
ArgosDataRepeat
Sets the repeat rate for the ArgosData instruction.
Syntax
ArgosDataRepeat(ResultCode, RepeatRate, RepeatCount,
BufferArray)
ArgosError
Sends a "Get and Clear Error Message" command to the transmitter.
Syntax
ArgosError(ResultCode, ErrorCodes)
ArgosSetup
Sets up the datalogger for transmitting data via an Argos satellite.
Syntax
ArgosSetup(ResultCode, ST20Buffer, DecimalID, HexadecimalID,
Frequency)