Campbell Scientific CR1000 Measurement and Control System - Manual (Page 442)

Section 10. Troubleshooting
442
Figure 134: Potentiometer R3 on PS100 and CH100 Charger / Regulator
10.6 Terminal Emulator
CR1000 terminal mode includes command prompts designed to aid Campbell
Scientific engineers in operating system development. It has some features that
advanced users may find useful for troubleshooting. Terminal commands should
not be relied upon to have exactly the same features or formats from version to
version of the OS, however. Table Terminal Emulator Menu
(p. 443)
lists terminal
mode options. With exception of perhaps the C command, terminal options are
not necessary to routine CR1000 operations.
To enter terminal mode, connect a PC to the nine-pin RS-232 port on the CR1000
via serial cable or USB-to-serial cable. Open a terminal emulator program.
Terminal emulator programs are available in:
1. Campbell Scientific datalogger support software Terminal Emulator
(p. 468)
window
2. DevConfig (Campbell Scientific Device Configuration Utility Software)
Terminal tab
3. HyperTerminal, a communications tool available with many installations of
Windows XP or lower. Beginning with Windows Vista, HyperTerminal (or
another terminal emulator utility) must be acquired and installed separately.