Campbell Scientific CR1000 Measurement and Control System - Manual (Page 443)

Section 10. Troubleshooting
443
As shown in figure DevConfig Terminal Emulator
(p. 445),
after entering a terminal
emulator, press Enter a few times until the prompt CR1000> is returned.
Terminal commands consist of a single character and Enter. Sending an H and
Enter will return the terminal emulator menu
(p. 443).
ESC or a 40-second timeout will terminate on-going commands. Concurrent
terminal sessions are not allowed.
Table 115. CR1000 Terminal Commands
Option Description Use
0 Scan processing time; real time in seconds Lists technical data concerning program scans.
1 Serial FLASH data dump Campbell Scientific engineering tool
2 Read clock chip Lists binary data concerning the CR1000 clock chip.
3 Status Lists the CR1000 Status table.
4 Card status and compile errors Lists technical data concerning an installed CF card.
5 Scan information Technical data regarding the CR1000 scan.
6 Raw A/D values Technical data regarding analog-to-digital conversions.
7 VARS Lists Public table variables.
8 Suspend / start data output Outputs all table data. This is not recommended as a
means to collect data, especially over
telecommunications. Data are dumped as non-error
checked ASCII.
9 Read inloc binary Lists binary form of Public table.
A Operating system copyright Lists copyright notice and version of operating system.
B Task sequencer op codes Technical data regarding the task sequencer.
C Modify constant table Edit constants defined with ConstTable /
EndConstTable. Only active when ConstTable /
EndConstTable in the active program.
D MTdbg() task monitor Campbell Scientific engineering tool
E Compile errors Lists compile errors for the current program download
attempt.
F VARS without names Campbell Scientific engineering tool
G CPU serial flash dump Campbell Scientific engineering tool
H Terminal emulator menu Lists main menu.
I Calibration data Lists gains and offsets resulting from internal calibration
of analog measurement circuitry.
J Download file dump Sends text of current program including comments.
K Unused
L Peripheral bus read Campbell Scientific engineering tool
M Memory check Lists memory-test results
N File system information Lists files in CR1000 memory.
O Data table sizes Lists technical data concerning data-table sizes.
P Serial talk through Issue commands from keyboard that are passed through
the logger serial port to the connected device. Similar in
concept to SDI12 Talk Through.