Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 75)

PFadvantage DICKEY-john Seed Manager
Ag Leader Technology Application Rate Mode
September 2003 2-63
Product: Press EDIT key. You can select an existing
product and press ACCEPT key or create a new product
by pressing CREATE NEW key. Press EDIT NAME key
and enter name of product. Use Left or Right Arrow keys
to select a character. Use Up or Down Arrow key to
change the character. To erase a character in the name,
highlight that character and use UP or DOWN ARROW
key to scroll to the blank space between "9" and "A". Set
every character and press ACCEPT key twice.
Units: Set to SEEDS.
Ground Speed Sensor: Set primary speed sensor to
SERIAL. The monitor will get ground speed from the
serial cable connection to the Seed Manager. Leave the
secondary speed sensor set to WHEEL and do not change
the Speed Sensor Pulses/100 ft. Also do not perform a
distance calibration using wheel selection. No calibration
is needed when primary speed is set to SERIAL.
Note: This setting affects all configurations.
App Distance From GPS: Ignore setting. This setting
pertains to using a .tgt prescription file.
Full Swath: Ignore setting. Swath automatically comes
from serial port of the DICKEY-john.
Tgt Units: Contrler Units: Ignore setting. This setting
pertains to using a .tgt prescription file.
Target Rate Increment: Ignore setting.
Actual Rate Scale Factor: Set to 1.000.