Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 22)

Card Setup PFadvantage
All Modes Ag Leader Technology
September 2003 2-10
Logging Hours Available/Logging Interval
1 sec 2 sec 3 sec
Ag Leader 32MB ATA
Flash Card 400 800 1200
NOTE: The logging hours available can vary from the numbers shown above
due to the number of separate files that can be stored on the card.
Log File The PFadvantage requires a log file to store data on a memory card. Harvest,
Site Verification and Application rate mode log files will have a “.yld”
extension. All log files will be named with the date the file was created.
Example: 02081502.yld, second file created on 08/15/2002.
IMPORTANT: Data must be copied to each log file before you read the
card into your computer. The monitor automatically copy copies data to
the card upon shutdown.
Using the Ag Leader ATA FLASH card a new log file must be created for
each day. You can not add to an old log file after a new file has been created
but you can store multiple log files on one card.
In order to log instantaneous GPS data or copy field and load data to a
memory card, a log file must be selected. Every time you turn on the
monitor, the monitor will prompt you to select or create a log file. Refer to
the steps below to select or create a log file after the monitor has been turned
on.
Step Action
1 Select Log File and press the EDIT key.
2 Select a log file or press CREATE FILE key to create a new log file.
3 With the desired file selected, press the ACCEPT key.
NOTE: After you read all the log files on your card into your computer (and
make backup copies of files), it is recommended to erase the log file(s) on the
card.