Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 48)

Grain Setup PFadvantage
Harvest Mode Ag Leader Technology
September 2003 2-36
Dry lbs / bu This setting is the pounds / bushel value that the monitor uses to calculate
bushels. You can change this setting for all grains except corn (56 lbs / bu),
soybeans (60 lbs / bu) and wheat (60 lbs / bu).
Dry moisture This setting is the moisture value that the monitor uses to calculate dry
bushels.
Example:
Corn – 15%
Soybeans – 13%
Scale Factor For grass seed the recommended setting is 1. Settings are 1, 10, 100.
Moisture offset Refer to the Initial Calibration Sheet for the correct setting. Do not readjust
the moisture offset number after you have performed a moisture calibration.
Stop Height This setting determines how high the combine head must be raised to make
the monitor stop counting area. This number can be automatically set under
the CAL, STOP HGT key.
M1 Refer to the Initial Calibration Sheet for the correct setting.
S1 Refer to the Initial Calibration Sheet for the correct setting.
Setting Initial C
Numbers The 11 C Numbers, C1 through C11 determine the pounds of grain that the
monitor calculates. The C numbers initially should be set to the same
values that appear on your Initial Calibration Sheet, but they will change
and become more accurate after you have calibrated.
Do not change the C numbers after you have calibrated.
You only need to set the C11 number to its initial value. When you set the
C11 number, the C2-C10 numbers will automatically change to the correct
value. Do not set the C1 number. It is adjusted automatically when you do
a vibration calibration.