Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 191)

PFadvantage Application Rate – Monitor/Control
Ag Leader Technology Application Rate Mode
September 2003 4-41
Introduction The PFadvantage console is designed to easily mount in a tractor cab or
other vehicle and connect to an application rate controller or flow meter
device. The PFadvantage can monitor and/or control the application rate of
a controller or flow meter device. See the setup section for instructions for
compatible controllers and flow meter devices. You can monitor and/or
control application rates for:
• Planting rates
• Spraying rates
• Fertilizing rates
NOTE: The PFadvantage can monitor and/or control only one application
rate of a single product.
Requirements
• GPS receiver
• Memory card
• Application rate controller or flow meter device (controller console
must have a 9-pin serial port for PFadvantage to do application rate
control)
• Cables to connect to the application rate controller or flow meter device
• Monitor-mounting bracket
NOTE: Cables and monitor-mounting bracket can be ordered from your
Ag Leader Technology dealer. Refer to the options section for instructions
on ordering cables.
Application Rate
Operating Mode To monitor or control application rates, the PFadvantage must be set on the
“Application Rate” operating mode. To view and change the operating
mode you must press the SETUP key and then the CONSOLE key.
Instructions for changing the operating mode are in the operation section
under “Updating Operating Program.”