Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 24)

Creating, Naming Fields, Loads PFadvantage
All Modes except App Rate Ag Leader Technology
September 2003 2-12
Recommendations NOTE: If using Application Rate Mode, refer to the Controller
Setup instructions on how to create and change fields. Refer to this
section for how to name fields and loads.
All the information recorded by the PFadvantage must be recorded in a
field and load. The field and load that the monitor is set on is located on the
top line of the display on the main operating screen.
Fields
It is recommended that you create all the fields and name them before you
begin to use the PFadvantage. The monitor will use the same set of fields
you create for each operating mode (harvest mode, application rate mode,
site verification) of the monitor. You can create and name your fields using
any operating mode. You should choose field names that you can use year
after year.
Loads
You may decide to create, and name loads within fields before you use the
PFadvantage however, additional loads may be created and named as
needed during field operations. Each operating mode of the PFadvantage
will have its own set of loads for each field.
Definition:
Load: A load is used to subdivide a field into smaller sections. The
monitor load is not associated with the combine tank, wagon, or
truck load.
Load
Field