Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 219)

PFadvantage Troubleshooting
Ag Leader Technology
September 2003 6-1
Introduction Use the procedures on the following pages to troubleshoot, calibration,
operation, and installation problems. If you cannot pinpoint the problem,
call Ag Leader Technology at 515-232-5363 (fax: 515-232-3595).
If you think you have a hardware failure, call Ag Leader Technology and a
service unit or replacement hardware will be shipped to you immediately.
Subject Mode Page
Zero Flow in Bu/Hr or lbs/Hr Harvest 6-3
Bu/Ac Yield or lbs/Ac Too High or Low Harvest 6-4
High Yield Reading After Stopping Harvest 6-9
Average and Instantaneous Yield Do Not Agree Harvest 6-9
Elevator Speed is Zero or Erratic Harvest 6-9
Incorrect Acre Counting Harvest 6-10
Incorrect Moisture Harvest 6-10
Moisture Readings of 5% or Erratic Harvest 6-11
Moisture is too high or too low Harvest 6-11
Moisture readings are high Harvest 6-11
Moisture reading decreases drastically/suddenly Harvest 6-11
Erratic moisture sensor signal with moisture sensor
installed in auger tube Harvest 6-11
Moisture continually reads 5% with elevator mount Harvest 6-12
Auger doesn’t come on moisture remains constant Harvest 6-12
Incorrect Grain Weight (lbs) Harvest 6-12
Incorrect Temperature Reading Harvest 6-13
AREA OFF Always Displayed Harvest 6-14
Monitor Chirps While Harvesting Harvest 6-14
Incorrect Distance and MPH Harvest 6-15
Monitor will not power up All 6-16
Monitor Has No Display All 6-16
No GPS Signal All 6-16
On Screen Map Does Not Appear All 6-16
On Screen Map Does Display Area Covered on a
Previous Day All 6-16
Boundary Map Does Not Appear All 6-16
Differential correction fades in and out All 6-17