Ag Leader PFadvantage Harvest & Application Operators Manual - Manual (Page 43)

PFadvantage Vehicle Setup
Ag Leader Technology Harvest Mode
September 2003 2-31
Changing a Setting Step Action
1 Use the UP or DOWN ARROW keys to select the item you want
to change. The item is selected when a black filled rectangular
box surrounds the entire line.
2 Press the EDIT key and then use the UP or DOWN ARROW keys
to change the number or setting.
3 Once you have changed a setting press the ACCEPT key. Press
the EXIT key once you have made all the settings.
Elevator
pulses/revolution Refer to the Initial Calibration Sheet for the correct setting for your
combine.
Sprocket teeth Refer to the Initial Calibration Sheet for the correct setting for your
combine.
Combine scale
factor Refer to the Initial Calibration Sheet for the correct setting for your
combine.
IMPORTANT:
• Never change the scale factor during harvest. Doing so will cause
the monitor to lose calibration accuracy and you will have to set the
monitor on different grain types and recalibrate every grain type.
• All of your calibration loads and data loads must be harvested using
the same scale factor setting otherwise you will have severe
calibration problems that possibly can not be corrected.