HP StorageWorks XP Remote Web Console Software User Manual
Page 74
Performing XP Remote Web Console Operations 74
Table 3.6. If the priority is the same, the log information is output in the order of the operations performed.
Table 3-6
LUN Manager Operation and Priority of Log Information Output
Operation Target
of
Operation
Priority
LU 2
Host Group
1
WWN 1
Delete
DKC connection WWN
2
LU 4
Host Group
3
Add
WWN 3
Host Group
3
WWN 3
Changing Host Mode
3
Command Device
4
Command Device Security
4
OFF 3
Change
LUN Security
ON 1
•
Examples of the combination of multiple operations that are performed for one target at one time and the
output log information are as follows:
•
Add → Delete: The operations cancel each other; therefore, the log information is not output.
•
Change → Delete: The log information only on the Delete operation is output.
•
Change 1 → Change 2: The log information only on the Change 2 operation is output.
•
Add → Change: The log information is output as an Add operation; however, the contents of the setting
are output according to the setting of the Change operation.
•
If a host group has been deleted, the following operations that have been performed for that Host Group
are not output as log information:
•
Changing host mode
•
Changing Host Group
•
Adding or deleting paths
•
Adding, changing, or deleting WWN
Note 4:
The notes on the log information that is output, when two or more Port settings are set, are as follows:
•
When two or more operations are performed for one target, the log information is output as one entry.
•
The log information is output in the order of the operations performed.
•
An example of the combination of multiple operations that are performed for one target at one time and the
output log information is as follows:
•
Change 1 → Change 2: The log information only on the Change 2 operation is output.
Note 5:
The notes on the log information that is output, when two or more LUSE settings are set, are as follows:
•
When two or more operations are performed for one target, the log information is output as one entry. For
example, if you have created one LUSE volume and then created another LUSE volume using the previously-
created LUSE volume, the log information is output as "create.”
•
The log information is output in the order of the operations performed.
•
The examples of the combination of multiple operations that are performed for one target at one time and
the output log information are as follows:
•
Create LUSE volume → Delete LUSE volume: The operations cancel each other, therefore the log
information is not output.
•
Create LUSE volume 1 → Create LUSE volume 2 → Create LUSE volume 3 using LUSE volume 1 and
LUSE volume 2 → Delete LUSE volume 3: The log information only for the Create LUSE volume 1
operation and Create LUSE volume 2 operation is output.
Note 6:
The log information is output at the end, no matter when the Cache LUN XP operation is performed.