HP StorageWorks XP Remote Web Console Software - Manual (Page 101)

Setting SNMP Agent Properties 101
4-3-3 Adding A Community Name
To add a community name:
1. Change to Modify mode.
2. Click Install ( ). Click the SNMP IP Security tab.
3. In the Community & Trap box, select and right-click on Community. The Add Community pop-up menu is
displayed (see Figure 4-5).
4. Select the Add Community command. The Community pane (see Figure 4-6) is displayed.
5. In the Community text box, enter the desired community name. You can use up to 180 alphanumeric
characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can also use spaces, except at the
beginning or the end of the name.
6. Click OK. The new community name is displayed in Community & Trap, but the changes are not yet
implemented in the subsystem.
7. If you want to add one or more IP addresses to the new community, see section 4-3-6.
8. If you want to apply the changes to the subsystem, click Apply. Click OK.
Figure 4-5 Add Community Pop-Up Menu
Figure 4-6 Add Community Pane