HP StorageWorks XP Remote Web Console Software - Manual (Page 103)

Setting SNMP Agent Properties 103
Figure 4-8 Change Community Pop-Up Menu
Figure 4-9 Change Community Pane
4-3-6 Adding Community IP Addresses
To add a community IP address:
1. Log on to open the XP Remote Web Console main pane and then click Install ( ). Click the SNMP IP
Security tab to display the SNMP IP Security pane (Figure 4-2).
2. Select and right-click the desired community to display the Add Community popup menu (see Figure 4-10).
3. Select the Add IP Address command. The Add IP Address pane is displayed (see Figure 4-11).
4. In the IP Address box, enter a new IP address or select the existing IP address.
5. Click OK. The new IP address is displayed in the Community & Trap box, but the change is not yet
implemented to the subsystem.
6. If you want to apply the changes to the subsystem, click Apply. Click OK. If you want to cancel the
changes, click Cancel.