HP StorageWorks XP Remote Web Console Software - Manual (Page 126)

Configuration File Loader 126
5-4-2-4 First Error Check
The first error check is performed when the spreadsheet file is imported. The first error check verifies that the
spreadsheet is properly formatted. If there is an error, the spreadsheet is rejected, and an error message is
displayed. Errors detected at the first check include the following:
• The first row of the spreadsheet (the declaration line) is not correctly written, or the stated product is not
installed. For more information on the declaration line, refer to section 5-2-2-1.
• The spreadsheet file is not in text file format (the file is a binary file).
• There is no function tag in the spreadsheet. For more information on the function tag, refer to section 5-2-2-
2.
• The file name is incorrect (e.g., the extension is not “.spd”, or the file name exceeds the maximum number
of letters).
• The number of letters in a row exceeds 128.
• The number of rows in a spreadsheet exceeds 400,000.
5-4-2-5 Second Error Check
In the second check, the spreadsheet settings are verified. Any errors found are displayed on the Error
Information list. This second check is performed before the Apply button becomes available. Figure 5-16 shows
the flow of the second check.
The second error check consists of two different types of the checks. These checks are shown in Figure 5-16 as
the Level 1 and Level 2. The Level 2 check is performed only when no error is found by the Level 1 check. Each
level of the check of the second error check detects the following errors:
• Level 1 check (the format and parameters are checked):
• A function tag is not supported.
• A setting value is incorrect or omitted.
• The setting range is incorrect. The correct ranges are as follows:
CU: 00 - 3F
LDEV: 00 - FF
LUN: 0000 - 03FF
Group ID: 00 - FE
Host Mode: 00 - 2F
• Level 2 check:
The current settings are compared to the imported settings and checked for logical consistency. Note that
certain errors can only be detected by the third check.
When you import a spreadsheet with no errors detected, the pane displays Ready above the error information
list, and the Apply button becomes available.