HP XP P9500 Storage - Manual (Page 158)

When to select this option Host mode options No.
• The mini-port driver is used.
•
TPRLO=2 is specified for the mini-port driver parameter of the host bus
adapter.
When all of the following conditions are satisfied: Automatic recognition function
of LUN 7
•
The host mode 00 Standard or 09 Solaris is used.
•
SUN StorEdge SAN Foundation Software Version 4.2 or higher is used.
• You want to automate recognition of increase and decrease of devices
when genuine SUN HBA is connected.
When all of the following conditions are satisfied: No display for ghost LUN 12
• The host mode 03 HP is used.
•
You want to suppress creation of device files for devices to which paths
are not defined.
When you want to be informed by SIM (service information message) that the
number of link failures detected between ports exceeds the threshold. SIM report at link failure
1
13
When all of the following conditions are satisfied: HP TruCluster with Continuous
Access Synchronous function 14
• The host mode 07 Tru64 is used.
•
You want to use TruCluster to set a cluster to each of P-VOL and S-VOL for
Continuous Access Synchronous or Continuous Access Journal.
When all of the following conditions are satisfied: HACMP 15
• The host mode 0F AIX is used.
•
HACMP 5.1 Version 5.1.0.4 or later, HACMP4.5 Version 4.5.0.13 or
later, or HACMP5.2 or later is used.
When Veritas Cluster Server is used. Veritas Cluster Server 22
When you want to shorten the recovery time on the host side if the data transfer
failed REC Command Support
1
23
When all of the following conditions are satisfied: Set/Report Device Identifier
enable 33
•
Host mode 03 HP or 05 OpenVMS
2
is used.
• You want to enable commands to assign a nickname of the device.
•
You want to set UUID to identify a logical volume from the host.
When you want to control the following ranges per host group when receiving
Target Reset: Change the nexus specified in
the SCSI Target Reset 39
•
Range of job resetting.
•
Range of UAs (Unit Attentions) defined.
When all of the following conditions are satisfied: V-VOL expansion 40
• The host mode 0C Windows or 2C Windows Extension is used.
•
You want to automate recognition of the THP V-VOL capacity after
increasing the THP V-VOL capacity.
When you want to execute commands to recognize the device preferentially. Prioritized device recognition
command 41
When IBM Z10 Linux is used. Prevent "OHUB PCI retry" 42
When the command queue is full in the P9500 storage system connecting
with the HP-UX host, and if you want to respond Queue Full, instead of Busy,
from the storage system to the host. Queue Full Response 43
158 Managing logical volumes