HP LeftHand P4000 SAN Solutions User Manual
Page 277
allowing multiple iSCSI application server connections
to a volume,
before changing server connections and permissions,
changing RAID erases all data,
check Safe to Remove before replacing disk,
create SmartClone volume or Remote Copy before
rolling back snapshot,
decreasing volume size not recommended,
deleting management group causes data loss,
deleting volume permanently removes data,
disabling network interface,
do not defragment file system unless required,
do not delete individual snapshot from snapshot set,
do not delete last snapshot of Network RAID-5 or
Network RAID-6 volume,
iSCSI failover issues with noncompliant iSCSI initiator
with load balancing,
log into management group from one CMC only,
minimum configuration for fault tolerance,
plugging NICs into same switch for Link Aggregation
Dynamic Mode,
resetting storage system to factory defaults erases all
data and configuration information,
stop applications and log off iSCSI sessions before
deleting volumes or snapshots,
verify that NIC bond works properly,
virtual manager requires manual activation,
volumes with Network RAID-0 not protected from system
failure or reboot,
warnings when using DHCP,
when changing management group to normal mode,
when to log off before changing iSCSI server settings,
where to install Failover Manager,
,
Centralized Management Console, setting up for remote
support,
Challenge Handshake Authentication Protocol see CHAP
changing
administrative group description,
changing RAID erases data,
cluster configuration,
clusters, for volumes,
data protection levels,
DNS domain name,
host names,
IP address of storage system,
local bandwidth,
maintenance mode to normal,
management groups,
network configuration,
order of NTP server access,
snapshots,
thresholds in a snapshot,
user password,
volume descriptions,
volume size,
CHAP
1-way,
2-way,
configuring with multi-byte character name,
editing,
iSCSI,
not required,
required,
requirements for configuring,
terminology in different initiators,
using,
volumes and,
characteristics of SmartClone volumes,
checklist for disk replacement,
choosing a RAID configuration,
client access to volumes,
clients, adding SNMP,
clone see SmartClone volumes
clone a volume,
clone point
and shared snapshots,
deleting,
SmartClone volumes,
cluster swap,
Cluster Utilization Summary, customizing on SAN Status
Page,
cluster-level data protection, Best Practice Summary,
clustered application servers
changing volume associations after deleting server
cluster,
creating,
deleting cluster,
clustering application servers,
clustering managers,
clustering servers,
clusters
Adaptive Optimization and,
adding,
adding storage system,
capacity,
comparing the load of two,
data protection levels,
deleting,
editing,
map view,
moving volumes between,
overview,
removing storage systems from,
reorder storage systems within,
repairing storage system in,
space reporting in,
swapping storage systems,
System Use window,
troubleshooting,
usable space in,
Use Summary window,
viewing capacity and useage of,
Volume Use window,
277