Badger Meter ORION Classic (CE) - Manual (Page 41)

Result: The Select gas drive circle screen is
displayed again.
5 Select the drive circle settings, then tap the
Select button
Figure 62: Select new gas drive circle
6 The IR Programming screen is displayed with the selected drive circle information highlighted
7 Align the optical head of the IR cable with the endpoint IR LED port and tap Program
Figure 63: New drive circle selected Figure 64: New drive circle programmed
Result: The gas endpoint is reprogrammed with the new drive circle information which is no longer highlighted.
ORION IR PROgRAMMINg
Page 41 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3