Badger Meter ORION Classic (CE) User Manual
User manual, Orion® endpoint utility
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- USER GUIDE
- Program Startup And Exit
- ORION Endpoint Utility Menu
- SETTING COM Ports
- ORION IR Programming
- Magnet Swipe Warning for IR Access
- Force Read
- Ping
- Modem Info
- Mode
- Start, Pause, Stop – Radio Modes
- IR Programming an ORION Migratable Endpoint (RTR)
- IR Force Read (HR-E LCD, HR-E, ADE)
- Listen
- Extended Status
- RTR Extended Status
- ENC Extended Status
- High Resolution (HR) E LCD Extended Status
- High Resolution (HR) E-Series Extended Status
- IR Programming Meter Size, Type and Units of Measure (RTR, ADE)
- Advanced IR Programming
- Setting GPS Location Manually
- Set Date and Time
- Get Battery Status
- Starting a Flow Rate Study
- IR Programming an ORION Migratable Gas Endpoint
- Start, Pause, Stop - Radio Modes
- IR Programming an ORION Classic Endpoint (RTR)
- IR Force Read (ADE)
- Listen
- IR Programming an ORION Classic Gas Endpoint
- Possible Drive Circles
- Reprogramming a Gas Drive Circle
- ORION Quick Read
- ORION Quick Read-Single
- ORION Profile Extraction
- ORION Network Communication Test
- E-Series Ultrasonic
- Settings
- Profile Extraction Defaults
- Logging Options
- Appendix
- Glossary
- Connecting an External Mobile Transceiver or Receiver
- Using the Handheld Keypad
- Handheld Factory Reset/Clean Boot
- IR Programming Bracket
- Status Codes
- Valid COM Ports
- Gas Meter Drive Rotation
- Technical Support