Badger Meter ORION Classic (CE) - Manual (Page 21)

3 Using the handheld keypad, enter the RTR odometer value in the Reading field
Result: The reading box is highlighted (Figure 22) to indicate a new value is entered in the field but not yet programmed.
Leading zeros are not required, however it may be helpful to enter leading zeros as visual confirmation Only seven
digits can be entered when programming an endpoint, regardless of the meter size
4 Align the optical head of the IR cable with the ORION Migratable endpoint IR LED port and tap Program
Result: The endpoint is programmed with the new value and the reading box is no longer highlighted. See Figure 23.
Figure 22: New reading entered Figure 23: New reading programmed
NOTE: N When programming an endpoint after clearing a tamper, verify that the programming and wire splicing were
successful Select ORION Quick Read - Single from the Menu to perform a Quick Read on the endpoint If the
endpoint still reports “Tamper” in the Status field, check the wire splices, repair as necessary and then repeat the
programming procedure above
DO NOT STOP AN ENDPOINT BEFORE FIXING A TAMPER. RESTARTING A STOPPED
ENDPOINT CLEARS THE HISTORICAL INTERVAL DATA (PROFILE DATA) AND PLACES FIXED
MODE ENDPOINTS INTO MOBILE MODE. ENDPOINTS IN MOBILE MODE MAY NOT REVERT
TO FIXED MODE FOR UP TO 48 HOURS.
ORION IR PROgRAMMINg
Page 21 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3