IAI America RCP2W-GRLS - Manual (Page 97)

87
9. Maintenance/Inspection
9.8.2 Lever Type
Greasing the Gears
(1) Applicable grease
The following grease is applied to the gears before the gripper is shipped from the factory.
Kyodo Yushi Multemp AC-D No. 2
Use lithium spray grease. Take note that grease should not be sprayed for more than 1 second.
(2) How to apply grease
[1] Use a flathead screwdriver to turn the
opening/closing screw located deep at the center
clockwise to move the levers toward the ends of their
respective strokes.
[2] Spray grease at the gear meshing locations
(3 locations; keep the spray time to a maximum of 1
second at each location).
After spraying, turn the opening/closing screw to
move the levers back and forth several times to
spread the grease evenly. Remove excess grease or
grease spatters in surrounding areas.
Warning
• Never use fluorine grease. If fluorine grease is mixed with lithium grease, the lubricating function of
grease will drop and the machine may suffer damage due to increased friction.
• Do not use spray oil. Be sure to use spray grease. Keep the spray time to a maximum of 1 second,
and never spray more than once. If too much grease is applied, excess grease may flow into the
electronic components and cause malfunction.
Open/close screw
Gear meshing location
Gear meshing location
Caution
•
•
In case the grease got into your eye, immediately go to see the doctor to get an appropriate care.
After finishing the grease supply work, wash your hands carefully with water and soap to rinse
the grease off.