IAI America RCP2W-GRLS - Manual (Page 32)

22
3. Installation Environment, Storage Environment
3. Installation Environment, Storage Environment
3.1 Installation Environment
Install the gripper in an environment meeting the conditions listed below.
x Not be exposed to direct sunlight.
x Be free from irradiating heat coming from a heat treatment furnace or other equipment that generates a
large amount of heat.
x Have surrounding air temperature of 0 to 40°C.
x Have humidity of 85% or below (non-condensing).
x Be free from corrosive or flammable gases.
x Be free from excessive dust and suitable for normal assembly work.(Excludes dust-proof specification
RCP2W-GRSS and RCP2W-GRLS.)
x Be free from oil mist or cutting oil.
x Be free from impact or vibration.
x Be free from strong electromagnetic waves, ultraviolet light or radiation.
x Be free from chemicals that may affect the gripper. Chemical resistance is not considered in the design
of this product.
In general, the gripper should be used in an environment where the operators can work without wearing
any protective equipment or gear.
3.2 Storage Environment
The storage environment should basically conform to the installation environment. If the gripper is to be
stored for an extended period of time, provide appropriate measures to prevent dew condensation.
The gripper is not packed with drying agent, unless otherwise specified by the user. If the gripper is to be
stored in an environment where dew condensation may occur, take appropriate measures to protect the
entire package, or the gripper itself (after unpacking it), from the detrimental effects of dew condensation.
The gripper can withstand a surrounding air temperature of up to 60
qC for a short period. If the gripper
must be stored for over a month, keep the surrounding air temperature at 50 qC or below.