Alamo TS-100A - Manual (Page 92)

© 2005 Alamo Group Inc. Section 9 - 10
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
Hose From Boom
(Motor Case Drain)
Blue Platic Tie
Hose From Oil
Cooler to Tank
return, No Plastic
Tie
Boom / Head Installation
12. Routing Boom Hoses to Pump The Boom hose to the pump will be routed on the RH Side
of tractor, They will be run through sleeving material and hose support bracket (See Figure 18).
The Pump hoses must be connected correctly to the boom and pump. There are 2 Pump to motor
hoses and 1 motor case drain return hose for a total of 3. (Note Motor Case Drain hose will be run
through the Oil Cooler and then return to tank).
First is the # 20 hose with the red plastic tie the lower connection at Boom, (See Figure
17), this is the pressure supply from the pump lower connection at pump (See Figure 20) to the
motor connection at the boom.
Figure 17
Red Tie
Blue Tie
Orange Tie
Figure 19
RH Side
of Tractor
Figure 18
Figure 20
Red Tie
(Bottom Fitting)
Orange Tie
(Top Fitting)
No Tie (F/ Oil
Cooler to Tank)
Second is the # 20 hose with the orange plas-
tic tie the upper connection at boom (See Figure 17).
This is the Return hose from the motor upper connec-
tion at pump (See Figure 20).
Third is the # 16 Hose with the blue plastic tie
the middle connection at the boom (See Figure 17)
which is the case drain from the motor. This hose
connects to the Oil Cooler / Fan Assembly which is
mounted under tractor bolster behind hydraulic tank
(See Figure 19) . There is a short #16 hose (See
Figure 19) which will not have a plastic tie on it that
will connect to the oil cooler, and then goes to the tank
to a return port (See Figure 20).
13. Pump Hose Routing at Tank. The hose routing
at tank is shown as reference to the Pump hose
routing which most of will already be connected when
the tank and pump assembly is shipped from the
factory. All hoses that you must disconnect and re-
connect during pump and/ or tank assembly, refer to
this figure for the correct location of hose (See Figure
21). DO NOT start tractor before all steps of the
installation is completed, if tractor is started damage
to the hydraulic system will occur.
Sleeving Material
for Hoses
Hose Support
Bracket